Kawasaki R8126 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Véhicule tout-terrain Kawasaki R8126. Kawasaki R8126 User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Owner's Manual
Owner's Manual
with Assembly Instructions
with Assembly Instructions
For Model R8126
For Model R8126
Please read this manual and
• Please read this manual and
save it with your original
save it with your original
sales receipt.
sales receipt.
Tool needed for assembly:
• Tool needed for assembly:
Phillips Screwdriver
Phillips Screwdriver
(not included).
(not included).
Use only with a Power Wheels
• Use only with a Power Wheels
®
®
12 Volt Lead-Acid Rechargeable
12 Volt Lead-Acid Rechargeable
Battery and a Power Wheels
Battery and a Power Wheels
®
®
12 Volt Charger with type 12V
12 Volt Charger with type 12V
connector (both included).
connector (both included).
Vue de la page 0
1 2 3 4 5 6 ... 19 20

Résumé du contenu

Page 1 - Owner's Manual

Owner's Manual Owner's Manual with Assembly Instructions with Assembly Instructions For Model R8126For Model R8126• Please read this manual

Page 2 - TABLE OF CONTENTS

10• Insert two #10 x 1" screws into the clip and tighten.• Turn the vehicle upright.13• While holding the handlebar in place, carefully turn t

Page 3 - RIDING HAZARD

11• Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils.• Place the labels exactly as sho

Page 4 - Fasteners Shown Actual Size

12IMPORTANT! Use only a Power Wheels® 12 volt lead-acid rechargeable battery. Use of any other battery will damage your vehicle. Make sure that you ch

Page 5 - PARTS PICTURE

13• Your Power Wheels® battery is a non-spillable, sealed lead-acid battery. It must be recycled or disposed of in an environmentally sound manner.• D

Page 6 - BATTERY CHARGING

14 RIDING HAZARD• Prevent Injuries and Deaths • Direct Adult Supervision Required. • Never Ride at Night. • Keep Children Within Safe Riding

Page 7 - ASSEMBLY

15As assembled, your vehicle is ready to roll in low speed (21/2 mph, maximum). It has been pre-set so it will only operate in low speed. After your c

Page 8

16• Check all screws and their protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pi

Page 9

17IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, ple

Page 10 - R8126a-0920

18PROBLEM POSSIBLE CAUSE SOLUTIONShort run time (Less than1 - 3 hours per charge)Undercharged battery Charge the battery. A new battery should have be

Page 11 - DECORATION

19PROBLEM POSSIBLE CAUSE SOLUTIONVehicle runs in low speed, but does not run in high speed.Please note: The vehicle is designed to operate in low spee

Page 12 - BATTERY INSTALLATION

2Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Page 13 - BATTERY CARE AND DISPOSAL

Or contact your local independently owned and operatedPower Wheels® Authorized Service Center.For the location nearest you, visit us on-line at www.po

Page 14 - SAFE DRIVING RULES

3ELECTRICAL HAZARD RIDING HAZARD• Prevent Injuries and Deaths • Direct Adult Supervision Required. • Never Ride at Night. • Keep Children With

Page 15 - VEHICLE OPERATION

4• If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the stor

Page 16 - LIMITED WARRANTY

5PARTS PICTURE2 1 Vehicle 2 Handlebar 3 Seat 4 12 Volt Battery 5 Base Plate 6 Steering Column Cap 7 Front End 8 12 Volt Charger 9 Clip10 Shovel

Page 17 - PROBLEMS AND SOLUTIONS

6ELECTRICAL HAZARDImportant Notes• Your new battery must be charged for at least 18 hours before you use it in your vehicle for the first time.• We r

Page 18

7Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be t

Page 19

8• Fit another #8 x 3/4" screw through the hole shown in the front end and into the vehicle. Tighten the screw.Hint: You may need to adjust the

Page 20

9Steering Column Opening• Fit a 3/16" washer onto the #8 x 2" screws.• Insert the screws with washer into the base plate plate and tighten.

Commentaires sur ces manuels

Pas de commentaire