MODEL #840091FOR CUSTOMER SERVICEPOUR LE SERVICE APRÉS VENTEOU DU CONSOMMATEURPARA EL SERVICIOPARA EL CONSUMIDOR1-800-590-3723Printed in China 87-1904
1817INSTALLING THE CENTER PULLEYThe head assembly contains three pulleys. The firstpulley is on the is on the spindle shaft and the thirdpulley is on
SQUARING THE WORKTABLEThe combination square must be “true” when used tosquare the worktable. See Tools Required for Assembly. This is essential ino
NEVER OPERATE LASER IF THE UNIT IS DEFECTIVE OR THE COVER OR SEALIS DAMAGED.DO NOT SERVICE LASER. The laser unit must be returned to the factory for a
It is recommended that an approved ANSI full-face shield, that is impactresistant, be worn during all drill press operations. Shoul
9. Grasp the feed handles and rotate them toward the front of the drill press low-ering the drill bit onto the workpiece. This step is necessary to en
SETTING THE DRILLING DEPTH ADJUSTMENTTurn the drill press ON/OFF switch to the OFF position anddisconnect the AC power to prevent drill press from acc
DRILLING THROUGH WOOD:1. Position the workpiece so that the hole to be drilled is over the center hole onthe worktable.2. Place a piece of scrap mat
TROUBLE PROBABLE CAUSE SOLUTIONWhen drilling metal, it is a good practice to keep theworkpiece lubricated. This prevents galling and eventual sei
SPECIFICATIONSSPECIFICATIONSVoltage 120V 60 Hz Rated Current 7.8 ANo-Load Speed (motor) 1700 RPMMax. Distance From Spindle Axis To Surface Of Column:
found to be defective and subject to warranty. Alltrade retains the sole discretion to determine whether any item or part is nonconforming an
USING THE DRILL PRESS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29DRILLING WOOD . . . . . . . . . . . . . . . . . . . . . . . .
REPRESENTATIVE(S) HAS BEEN ADVISED OF THE POSSIBILITY OF ANY SUCHDAMAGES. IN NO EVENT, WHETHER AS A RESULT OF A BREACH OF CONTRACT,WARRANTY,
GENERAL SAFETY RULES – FOR ALL ELECTRIC POWER TOOLSREAD AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instruc-tions listed below m
This drill press is equipped with a grounded 3-wire power cord with a 3-prong plug.If the power cord will not fit into the wall plug, an approved adap
USE ONLY DRILL BITS, SANDING DRUMS, AND OTHER ACCESSORIES thatare designed for the various speeds of this drill press. The drill bits, sandingdrums
SECURE THE ELECTRICAL POWER CORD when the drill press is not in use toprevent unauthorized use of the tool and/or to prevent children from acciden-tal
FUNCTIONAL DESCRIPTIONCONTROLS AND COMPONENTS:1. Column Base2. Column Assembly3. Column4. Column Rack5. Table Crank6. Table Support7. Table Crank Asse
To minimize crank handle backlash, tighten the supportlock, rotate the elevation worm shaft clockwise, assemble the crank tightlyagainst the table sup
INSTALLING THE HEAD ASSEMBLYThe Head Assembly weighs approximately 55 pounds.Use caution when lifting it onto the column assembly. It is
Commentaires sur ces manuels