8" BENCH DRILL PRESS INSTRUCTION MANUALFOR CUSTOMER SERVICEPOUR LE SERVICE APRÉS VENTEOU DU CONSOMMATEURPARA EL SERVICIOPARA EL CONSUMIDOR1-800-5
17 18STORE OUT OF REACH OF CHILDREN. Equipment should be in a high locationor locked up to keep out of reach of children. It is not a toy.DO NOT TAMPE
Ensure that the switch toggle, when removed, is kept ina secure place. Once removed, the drill press will not start without it.ADJUSTING THE WORK TABL
1. Lift up the pulley cover (1).2. Release the belt tension by loosen-ing the tension lock knob (2) locatedon the side of the drill press head.Loosen
3. Turn the spring housing (5) counter-clockwise to increase the spring ten-sion or clockwise to decrease thespring tension.4. Turn nut (4 - inside) u
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.If the drill press must be used outside, use an extension cord labeled “
Warranty Performance By purchasing the product, purchaser expressly acknowledges and agrees that theirsole and exclusive remedy under this warranty sh
ALLTRADE AND/OR ITS REPRESENTATIVE(S), OR THE PURCHASER, INCLUDINGBUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND THEWARRANTY OF FITNES
SECTION FOURMAINTENANCE AND CLEANING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25ACCESSORIES . . . . . . . . . . . . . . . . . . .
GENERAL SAFETY RULES – FOR ALL ELECTRIC POWER TOOLSREAD AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructionslisted below may result in
This drill press is equipped with a grounded 3-wire power cord with a 3-prong plug.If the power cord will not fit into the wall plug, an approved adap
USE ONLY DRILL BITS, SANDING DRUMS, AND OTHER ACCESSORIES thatare designed for the various speeds of this drill press. The drill bits, sandingdrum
SECURE THE ELECTRICAL POWER CORD when the drill press is not in use toprevent unauthorized use of the tool and/or to prevent children from acciden-tal
FUNCTIONAL DESCRIPTIONCONTROLS AND COMPONENTS:1. Drill Bit 2. Column Assembly3. Feed Handles 4. Chuck Key5. Drill Chuck5. Head Assembly6. Knob (and m
Ensure the spindle taper (Q) and the tapered hole in thedrill chuck (R) are clean and free of any grease, lacquer, or rust preventativecoatings. Thes
LASER GUIDEUse of controls or procedures, or performance of proce-dures other then those specified herein may result in hazardous radiation
Commentaires sur ces manuels